The Cyber-Spy.Com Usenet Archive Feeds Directly From The Open And Publicly Available Newsgroup Sci.Electronics.Design
This Group And Thousands Of Others Are Available On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic, Opinions Or Content Posted To This Or Any Other Newsgroup. This Web Archive Of The Newsgroup And Posts Are For Informational Purposes Only.
Reply-To: "George Gonzalez"
From: "George Gonzalez"
Newsgroups: sci.electronics.design
References:
Subject: Re: X Y Plotter Help Needed
X-Newsreader: Microsoft Outlook Express 6.00.2600.0000
Message-ID:
NNTP-Posting-Host: 24.118.121.151
NNTP-Posting-Date: Wed, 11 Sep 2002 12:47:02 GMT
Organization: AT&T Broadband
Date: Wed, 11 Sep 2002 12:47:02 GMT
I suspect the pen-up-down circuit isnt too fancy,
it should be amenable to wire-tracing with a flashlight
and a bit of wire-tugging and cursing. You might find at most
a grounded-emitter power transistor driver and a bias resistor or two.
Regards,
George
"Al" wrote in message
news:afjay*-A81124.08305411092002@news.bellatlantic.net...
> I recently rescued an Allen Plotomatic 715 from our local recycling
> center. It had been modified. I was able to restore all of its functions
> except one.
>
> Pen up and down does not work. The wires had been cut off the actuator
> switch. Does anyone have a schematic of this beast? It uses 709 op-amps
> date coded for 1976. Whew! But it's nice. Built like a tank!
>
> Thanks in advance.
>
> Al
>
> --
>
> Remove * from the address to reply.
Go Back To The Cyber-Spy.Com Usenet Web Archive Index Of The sci.electronics.design Newsgroup
|