The Cyber-Spy.Com Usenet Archive Feeds Directly From The Open And Publicly Available Newsgroup Sci.Electronics.Design
This Group And Thousands Of Others Are Available On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic, Opinions Or Content Posted To This Or Any Other Newsgroup. This Web Archive Of The Newsgroup And Posts Are For Informational Purposes Only.
From: "Boris Nogoodnik"
Newsgroups: sci.electronics.basics,sci.electronics.design
References: <3d816727.129136963@news.pacific.net.sg> <3d820c12.171361860@news.pacific.net.sg>
Subject: Re: How to make/solder a circuit fast?
Organization: KGB, Ltd.
X-Newsreader: Microsoft Outlook Express 6.00.2800.1106
Message-ID:
Date: Fri, 13 Sep 2002 15:30:54 -0400
NNTP-Posting-Host: 24.191.172.224
NNTP-Posting-Date: Fri, 13 Sep 2002 15:30:43 EDT
"The little lost angel" wrote in message
news:3d820c12.171361860@news.pacific.net.sg...
> On Fri, 13 Sep 2002 01:39:10 -0400, "Boris Nogoodnik"
> wrote:
> >You may want to try the way pcbs are always have been made. Make a layout,
> >place the transparency with multiple instances of your layout on the large
board
> >covered with photoresist . Expose to UV, develop, etch, drill the holes and
> >then cut the individual boards apart.
>
> I've read some sites about the process. Is there anyway to do it
> without having to deal with chemicals?
>
> The only one I've come across is this Techniks Peel and Press thingy
> but not sure how well it would work for my needs and *budget*
>
>
If the board is very simple and components are not too small, you can draw by
hand using the Sharpie pen. But you still will have to etch and drill the
holes.
Go Back To The Cyber-Spy.Com Usenet Web Archive Index Of The sci.electronics.design Newsgroup
|