The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
From: "Bill Lewis"
Subject: Re: Coil antenna
Date: Wed, 18 Sep 2002 21:56:11 +0100
Organization: Kijoma Solutions Ltd
References: <email@example.com> <3D888614.firstname.lastname@example.org>
Reply-To: "Bill Lewis"
NNTP-Posting-Date: 18 Sep 2002 21:07:12 GMT
X-Newsreader: Microsoft Outlook Express 5.50.4807.1700
i think he meant what does he wind it on..
try a ferrite rod as used in LW / MW radios.
a longwave coil is centered about 200kHz, you could resonate that at 25khz
with lots of Capacitance and you may
still be ok for your 3 Meter Range.
if not buy two or three LW coils, stick em on one rod and connect them in
series or wind your own to get sufficient inductance for a reasonably
efficient 25kHz antenna.
wire gauge will need to be thin unless you want a monster coil ;o
Kijoma Solutions Ltd
RF - Analogue - Digital - Software
Electronic Product Design & Consultancy
Email : news@kiSPjoAMma.com ( remove the spam)
There are only 10 types of the people in the world
those who understand binary and those who don't
"Rene Tschaggelar" wrote in message
> Coil material is copper.
> gauge is unimportant. Your signal is proportional to the
> enclosed area. And proportional to the number of turns.
> But the inductivity also rises, therefore a few tests
> are necessary.
> Ing.Buero R.Tschaggelar - http://www.ibrtses.com
> & commercial newsgroups - http://www.talkto.net
> Mmsya wrote:
> > Hello all,
> > Please help. I am trying to build an antenna made of a coil to receive
> > signal from a 25KHz. transmitter. I would like to have the coil to be as
> > as possible and to be able to receive the signal within 3 meter
> > have the following question:
> > a- What type of core material should I use for the inductor?
> > b- Is wire guage important?
> > Any other factor should I be concern?
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup