The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
References: <%_wk9.52964$1C2.email@example.com> <3D9442F1.42F2FBAF@webaccess.net> <3D9467AC.9745AC66@webaccess.net> <8a%k9.56338$1C2.firstname.lastname@example.org>
Subject: Re: Any ideas on measuring radiation in the home ?
X-Newsreader: Microsoft Outlook Express 5.00.2919.6700
Date: Tue, 01 Oct 2002 04:35:27 GMT
NNTP-Posting-Date: Tue, 01 Oct 2002 04:35:27 GMT
Organization: AT&T Worldnet
I looked at the site. It appears to be restricted to power frequencies only
(60-180 Hz). Also, it seems to be a limited study on cows and barns. And
there are some lawsuits and political people involved also. I would say, a
limited exercise. I have noticed before that Cows and estrus, etc. seems to
be a subtle joke topic among some radio people.
The people who are 'in the know' would know what is going on anyway ! The
experimentation will be all documented and classified. Nowadays, with all
the proliferating dishes and towers and gizmos and lax regulation and
political and military targeting of people, many people seem to be operating
even outside the purview of controls or documentation ! I have seen a dishe
at ground level pointed straight across a busy road and another at an
intesection. I have seen a home with three dishes pointing almost
horizontally at different directions.
We are going to run into a gizmo bubble burst after the dot-com bubble burst
"milne_v" wrote in message
> "News2020" wrote in message
> > Thanks for the reply. Yes, I do find sparking even on disconnecting the
> > computer after switching it off. I had also disconnected almost
> > else that is on-line. One poster mentioned that the sparking is due to
> > line filter capacitance (in the case of the microwave oven).
> > To add to my postings so far, I continue to notice unnatural heating in
> > home at night. For example last night the temperature was 69 deg F in
> > area where I slept whereas it was 59 deg F outside (no internal source
> > heat). When I moved to a different location, the previous location
> > to 64 deg F and the new location rose to 67 deg F while the outside
> > at 59 deg F. This heating cannot be explained by body heat or even
> > fridge operation, I think.
> > To respond to some of the other posters' concerns : I am not paranoid,
> > Some of the posters have gone off the deep end in that direction. Not to
> > worry; I still have my senses. Just checking to see what this newsgroup
> > come up with in the positive direction and hoping I won't get bogged
> > with too many negative people.
> > "milne_v" wrote in message
> > news:email@example.com...
> > > Check the homes wiring system for ground or plumbing currents making
> > > sure that any inductive type appliances are not operating at the time.
> > > The ground system should not show much signal using a scope. If there
> > > are spiked transients on the grounding system while appliances are
> > > shut off then you can assume that something is causing them which is
> > > not associated with the normal operation of the homes electrical
> > > system. Finding the source is another story. Should such transients
> > > exist then they may also produce broadband AM radio interferance in
> > > the vicinity. Make sure that items such as triac dimmer swithches etc
> > > are also not operating. Ground currents and switching transients have
> > > been suspected as a cause of problems in rural areas in the past,
> > > there's no reason why they can't be a problem elsewhere. These types
> > > problems are generally the responsibility of the hydro provider.
> > > Getting them to inspect and correct may somewhat of a different
> > > problem.
> > >
> > > Mil
> > >
> > > "News2020" wrote in message
> > news:...
> > > > I forgot to add: it can maim, paralyze or kill you too (stroke,
> > > > heart attack/arrhythmia) depending upon how much intrigue is
> > Even
> > > > in that case, there will be no proof or evidence readily available.
> > you
> > > > have worked with these things, and yet choose to belittle the
> > > > involved in misuse, your judgement is in question, not mine. I was
> > merely
> > > > indicating the possibility of danger (if misused) which is widely
> > publicised
> > > > and well known.
> > > >
> > > > A person who downplays the hazards or denies the hazards of mis-use
> > > > equipment or gizmos is raising a serious question of honesty (or
> > > > competence to be given responsibility), I think.
> > > >
> > > >
> > > > "News2020" wrote in message
> > > > news:8a%k9.56338$1C2.firstname.lastname@example.org...
> > > > >
> > > > > < Thanks for the inputs so far and the circuit diagram, etc; I am
> > trying
> > to
> > > > > ignore the attacks and negativity.>
> > > > >
> > > > > I am not really 'worried' about this spark. The question was more
> > general.
> > > > > There is potential for a LOT of 'mischief' in this area of
> > And
> > > > > you will never have evidence to show. The damage will be
> > imperceptible.
> > Such
> > > > > as tones that match with brain frequencies and drive you nuts,
> > > > > brainwaves by thermal imaging, using imaging feedback to pump in
> > controlling
> > > > > brainwaves, small cancers in blood vessels, muscles, skin, brain,
> > blood
> > > > > cells, etc, a little burnt skin layers, some damage to the
> > > > > cataracts over a long period, unnoticeable loss of hearing, clots
> > under
> > the
> > > > > skin that eventually get infected and turn into cancers, etc...,
> > of
> > > > > power lines and home sheet metal fixtures and appliances to inject
> > 'really
> > > > > high-energy' microwaves, etc. And I am not talking product design
> > issues
> > > > > such as the shoe measuring device or monitors that one poster has
> > mentioned.
> > > > > I am talking deliberate, planned, secret people who could do such
> > things.
> > No
> > > > > one would know. No evidence unless you get the right measuring
> > devices.
> > The
> > > > > only question is, is it within the limits of the technology today.
> > the
> > > > > answer is yes, the devil is not very far. This kind of stuff has
> > around
> > > > > for quite some time. It is only a matter of further refinement and
> > > > > miniaturization and deployment, target/victim selection, etc.
> > > > >
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup