The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
From: "Richard Everett"
References: <2rrm9.25474$CN2.email@example.com> <3D9A4916.3291ABBF@webaccess.net>
Subject: Re: series connection of switching power supplies
X-Newsreader: Microsoft Outlook Express 6.00.2600.0000
Date: Thu, 03 Oct 2002 00:52:47 GMT
NNTP-Posting-Date: Wed, 02 Oct 2002 20:52:47 EDT
Thanks Chuck, it works fine. Good idea about the diodes.
"Chuck Simmons" wrote in message
> Richard Everett wrote:
> > I need a 56V (+/- 5V) power supply at about 20 to 30 amps. This is to
> > the servo amps for 3 servo motors. I happen to have two 28V
> > switching power supplies, each with a 40 amp output. Would it be crazy
> > try and use these hooked up in series? Would I need to have some sort
> > balancing resistor setup across the outputs for regulation?
> In my dark and distant past, I used power supplies in the range of 75
> volts and 1500 amps in series parallel. Parallel is tricky because of
> current hogging. Series works fine but you should use a "free wheeling"
> diode across the output of each supply. That is a rectifier diode
> reverse biased by the power supply when it is operating normally. Some
> switchers have a minimum load rating which may be as high as 10% of full
> load. A power resistor of appropriate resistance will insure that such
> supplies start normally.
> ... The times have been,
> That, when the brains were out,
> the man would die. ... Macbeth
> Chuck Simmons firstname.lastname@example.org
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup