Reply-To: "fred bartoli"
From: "fred bartoli"
Subject: Re: MOSFET overvoltage protection
Date: Tue, 8 Oct 2002 13:22:39 +0200
X-Newsreader: Microsoft Outlook Express 5.00.2314.1300
Organization: Guest of ProXad - France
NNTP-Posting-Date: 08 Oct 2002 13:20:33 MEST
Tony Williams a écrit dans le message :
> In article ,
> Bill Bowden <**firstname.lastname@example.org*> wrote:
> > Ok, I added a 12 volt zener across the gate (NTE5127A) and a 200
> > volt, 1 watt zener across the drain/source (NTE5105A) but I'm not
> > sure of the power rating for the drain zener.
> > Do you have an idea how much power the zener will need to dissipate?
> The zener should not conduct significantly during
> normal operation, because most of the stored energy
> should be going into the spark. However, the zener
> might have to cope with the unusual circumstance of
> (say) a spark plug not firing, so would have to be
> able to safely absorb regular 50mJ energy dumps.
> Perhaps you could resolve a slight nag about what
> you have done? On the contact breaker there is a
> capacitor, about 0.1uF to 0.2uF afair. This cap is
> an essential part of the Kettering ignition, it
> forms a resonant circuit with the coil, so that
> (when the c-b opens) the voltage across the coil
> rises in a (sort of) quarter-sine shape, up to
> a defined peak of 200 to 300 volts. This has two
> effects, it restricts the dV/dT that the c-b has
> to withstand, and it lengthens the spark time.
> This cap is critical. Is it still connected to the
> coil, or did it disappear in the modifications?
> Note that "200 to 300 volts". Your 200V TVS is
> probably too low. What you should have is (say)
> a 500V MOSFET, protected by about a 400V TVS.
> To get 400V you can put lower-voltage devices in
> series, enough so that their total power capability
> is 10W.
Yes, or simpler, a 400/500V avalanche rated Mosfet.
> Tony Williams.