The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
Reply-To: "fred bartoli"
From: "fred bartoli"
References: <3DACB831.F814C3D6@webaccess.net> <3DAD0481.A4004E95@NOSPAM.univ-lille1.fr> <3DAD0A0A.1F7BF2DD@webaccess.net>
Subject: Re: Photodiodes in photovoltaic mode, speed considerations.
Date: Wed, 16 Oct 2002 14:14:51 +0200
X-Newsreader: Microsoft Outlook Express 5.00.2314.1300
Organization: Guest of ProXad - France
NNTP-Posting-Date: 16 Oct 2002 14:13:26 MEST
Chuck Simmons a écrit dans le message :
> "s.d." wrote:
> > My two cents...
> > If you want speed you may buffer your photodiode with a transimpedance
> > amplifier.
> > That's the usual way. But still you'll need negative supply.
> > At least you can try to put a low impedance load to your diode at the
> > expense of lower gain.
> > Mind that in voltage mode the diode response is logarithmic with light
> > power.
> A negative supply is outside of allowed parameters. If it costs $0.10 it
> is outside of allowed parameters. A load on the diode is not allowed
> because because I cannot specify a buffer that operates that close to
> the negative rail. I figure I can just live with 100mV off the rail and
> since I see, in devices so far, 150 to 200 mV at desired power, I'm OK.
> The problem is speed for clock selection for the digital loop which
> depends on the diode speed in photovoltaic mode. I know some clock
> limits for some devices but I can't predict because I only get reverse
> specs and I don't know how these or area relate to speed.
> BTW, we did use loading for a while but it did not work with a
> population of parts we had because the effect of the load on voltage was
> less predictable and caused laser damage (i.e., the things failed).
> Unloaded photovoltaic is safe it would seem from our experience. Some of
> the population of lasers tend to require close to burnout current
> levels. This is within spec for the lasers but a real pain for me.
What is your laser power (current) ?
If it's low enough, you could simply sightly offset the laser & photodiode
pair form the ground by inserting one diode (or two) in the lower branch.
Then you'll have 0.7V (1.4V) room for a transimpedance amplifier with say
about 0.5V (1.2V) full scale output.
> ... The times have been,
> That, when the brains were out,
> the man would die. ... Macbeth
> Chuck Simmons firstname.lastname@example.org
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup