The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
From: firstname.lastname@example.org (R.Legg)
Subject: Re: Comparator snap on-off ??
Date: 16 Oct 2002 15:04:57 -0700
NNTP-Posting-Date: 16 Oct 2002 22:04:58 GMT
> I understand that the circuit requires hysteresis to function better
> and I have tried to apply it to the circuit. Applying it to the
> inverting input section works fine but when I try to apply it to the
> non-inverting input also it messes the inverting section up. The
> reference levels are provided by a resistor divider network and trim
> pots for fine adjustment. The input signal is provided by the ouptput
> stage of an op-amp that amplifies the thermistor being monitored. The
> level changes very slowly and as such causes oscillation at the
> transition points. What I am ultimately trying to find out is: How can
> I apply hysteresis to both sections at the smae time without
> interaction between the two?? Everything I have tried so far makes one
> section work as desired but not the other. Any ideas ??
The hyterisis components can work at much higher impedance levels than
the actual voltage divider if you place a resistor in series with the
relevent IC input pin. Develop your millivolt hysterisis across this
Because the circuits switch at different voltages, there shouldn't be
much interplay between the two.
You have to include the static hysterisis voltage in your setpoint
calculations, as it will seldom be symetrical about the original
calculated set points, depending on the output switch's compliance.
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup