The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
From: "Lord Garth"
Subject: Re: IR repeater using Sharp GP1U59
Date: Thu, 17 Oct 2002 23:19:07 -0500
Organization: Airnews.net! at Internet America
Abuse-Reports-To: abuse at airmail.net to report improper postings
NNTP-Posting-Time: Thu Oct 17 23:18:35 2002
NNTP-Posting-Host: !Zb_q1k-Y9h&b?7 (Encoded at Airnews!)
X-Newsreader: Microsoft Outlook Express 5.50.4133.2400
"Bob Nelson" wrote in message
> I've tried the circuit shown on the third link and did have success
> generating a signal with the sharp module but the modules I have are part
> a pre-made IR detector device that I can't seem figure out. The circuit
> I'd hate to tear into all these devices and wire just the module. It's a
> pretty simple circuit but I'm a total beginner and can't figure what the
> output is.
Looks like the output of the module is the trace on the top.
The bottom one goes right to ground and the middle one
goes from + input to a jumper to the anode of a diode and
finally to the module. That leaves the trace going to R1 and
the 47uF cap.
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup