The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
From: "Leon Heller"
Subject: Re: PCB routing
Date: Sat, 26 Oct 2002 14:10:30 +0100
References: <191C91BDFE8ED411B84400805FBE794C2DA011B9@pfs21.ex.nus.edu.sg> <email@example.com> <firstname.lastname@example.org>
NNTP-Posting-Date: 26 Oct 2002 15:14:35 GMT
X-Newsreader: Microsoft Outlook Express 5.50.4920.2300
"Bevan Weiss" wrote in message
> For a single sided board, things become much harder. I'd primarily worry
> about routing the power trace, and then again flood fill (removing dead
> areas of course) with ground copper. Rearranging signal traces to give
> nice wide channels joining copper fills.
That's how I design PCBs to make at home. I also add some redundant wire
links as necessary on some tracks to ensure that most of the board gets the
poured copper, as I usually don't have the room to reroute the tracks. An
added advantage is that one doesn't have to route the ground connections.
Leon Heller, G1HSM
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup