The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
From: firstname.lastname@example.org (Alan D Cleland)
Subject: Re: Sending an analog signal using RF components
Date: 26 Oct 2002 18:27:35 -0700
NNTP-Posting-Date: 27 Oct 2002 01:27:35 GMT
email@example.com (kajjeb) wrote in message news:<firstname.lastname@example.org>...
> I need to transmit an analog signal, ranging from 400 mV to 1V, to
> a point 100 feet away.My signal varies constantly(Not only 400mV or
> 1V, can also have any values in between).I also want to have the least
> number of parts possible because of budget limitations and space
> I think that I have 3 possible solutions:
> 1)Send that signal as it is.But I don't think there's a part that can
> send an analog signal by RF??
> 2)Convert that signal into a digital signal.Is there something that
> can send an at least 8 bit digital signal by RF?? I need to be as
> precise as I can.
> 3)Convert that signal into a serial signal.But then I would need a
> clock,a frame with a header,etc..
I saw a company called laipac that sells a transmitter and receiver
module that will send digital or analog signals over a range of about
500ft. They operate at
about 400mhz. Several frequencies are available. Small quantities can
at a resonable cost. www.laipac.com
Alan D Cleland
at a resonable cost
> So,could anybody tell me if I'm on the right path or if there's other
> solutions that I didn't think of? You could also give me a list of
> components that I could use or links to these parts or solutions.
> You can email me directly to the addresse above
> Thanks a lot,
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup