The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
NNTP-Posting-Date: Sat, 26 Oct 2002 23:30:56 -0500
Subject: Re: PCB routing
Date: Sun, 27 Oct 2002 00:31:04 -0400
X-Newsreader: Microsoft Outlook Express 6.00.2600.0000
X-MIMEOLE: Produced By Microsoft MimeOLE V6.00.2600.0000
X-Abuse-and-DMCA-Info: Please be sure to forward a copy of ALL headers
X-Abuse-and-DMCA-Info: Otherwise we will be unable to process your complaint properly
No, I don't work for them. Make sure you check out there shareware
"Alex C" wrote in message
> How do we determine thickness of line width to route when dealing with
> or signal traces on a PCB? Does the location ( either surface layer or
> sandwitch in between dielectric) changes the properties of the thickness
> the trace?
> normally what is the size of a min via drill to use for power or signal?
> also what is the clearance to use for these via if it's surrounded by a
> thanks for your expertise.
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup