The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
From: John Popelish
Organization: This space not available for advertising.
X-Mailer: Mozilla 4.7 [en] (Win98; U)
Subject: Re: Question about linear derating factor for MOSFETs
References: <firstname.lastname@example.org> <3DCF50E9.CF58D143@rica.net>
Date: Mon, 11 Nov 2002 07:15:29 GMT
NNTP-Posting-Date: Mon, 11 Nov 2002 02:15:29 EST
Phil Allison wrote:
> "John Popelish" wrote in message
> > Perhaps you could submerge the device in alcohol or freon in a large
> > chamber with all the air evacuated, so that all the space was filled
> > with saturated vapor. This can act as a heat sink over the whole
> > surface of the device with a thermal conductivity a few hundred times
> > higher than solid copper.
> ** I was pondering a source of chilled liquid mercury ( abound 0
> degrees C ) flowing across the undersurface in a laminar high velocity
> stream (like a solder flow bath) and then fed to a resevoir of solid CO2.
> What da ya reckon - a cool idea ?
Phase change is much better at carrying heat away than liquid flow.
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup