From: "Lukas Louw"
References: <email@example.com> <firstname.lastname@example.org> <email@example.com> <firstname.lastname@example.org>
Subject: Re: Question about linear derating factor for MOSFETs
X-Newsreader: Microsoft Outlook Express 6.00.2800.1106
NNTP-Posting-Date: Wed, 13 Nov 2002 11:07:54 GMT
Organization: AT&T Worldnet
Date: Wed, 13 Nov 2002 11:07:54 GMT
This company is one of the smaller extrusion outfits, and I've used them
when I need something in small quantities where a custom tool isn't
They don't have the stupid minimums that Thermalloy and ilk foist on you ,
and their pricing for custom fabrication, such as cutting, drilling and
milling is very reasonable.
If you need sheetmetal work, talk to John overt at www.par-metal.com. He
also does full custom in proto and very small quantities at more than
reasonable pricing, as well as the standard products offered on the site.
Hope that helps,
> I wish I had the volume to make a custom extrusion worthwhile...3 feet
> a year probably isn't high enough. :-)
> last week, I priced out some Thermalloy extrusions I was considering.
> They ranged from $600 to $1900 for 6 feet!! Melcor
> (http://www.melcor.com) had some nice bonded fin heat sinks at what
> thought was great prices. They're made for their thermoelectric
> coolers but will work fine for a lot of things and they have fan
> mounts too (purchsed separately). These are the ones I've been using
> in my calculations.