The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
Subject: Re: Problems with MOSFET drivers
Date: 15 Nov 2002 15:07:39 GMT
Organization: Concentric Internet Services
X-Mailer: Mozilla 4.79 [en] (Win98; U)
First, check your connections. Second, if you don't have a parasitic
diode across the drain and source, that may cause part of the problem.
Post a schematic to alt.binaries.schematics.electronic and maybe we can
help with the design.
Mike Poulton wrote:
> I'm in the process of building a big (4kW) solid state tesla coil. The
> basic idea is to use a mosfet H-bridge to drive the coil's primary from
> a 300VDC source. There is a small feedback winding on the coil as well,
> which provides a signal to switch the mosfets. The mosfets are driven
> with a single toroidal transformer with one primary and four
> secondaries. Each seconday goes to a fet, and they are phased to turn
> on one pair on the positive cycle and the other pair on the negative
> cycle. Therefore, the primary needs to be driven with a full bridge.
> To do this, I am using a pair of drivers from Microchip, the TC4421 and
> TC4422. These are supposedly bulletproof. They come in 5-pin TO-220
> cases and are designed for 9A output. I have the pair (one inverting,
> the other noninverting) in parallel pin-for-pin -- except the outputs,
> of course. The output has a .1uF DC blocking capacitor in series with
> the primary of the gate drive transformer. There is a 5.1V zener from
> the inputs to ground, and a 4.7K resistor between the feedback winding
> and the inputs. A .001uF cap goes from the inputs to ground as a low
> pass filter in order to ensure that the coil oscillates in 1/4 wave
> mode, not a higher mode. I have a .1uF bypassing capacitor right across
> the IC power leads. In order to start oscillation, I have to give the
> input a 5V pulse through a 330 ohm resistor in order to trigger a state
> change and get things going.
> Here's the problem: the drivers explode! Loudly and reliably. The top
> of the package disappears and you get to see the die. If the driver
> board is powered but the H-bridge is not, nothing happens. As soon as
> power is applied to the bridge (only 12VDC, not the full 300) and you
> give the input a 5V pulse, it goes nuts and the drivers explode. There
> is no output from the coil during the brief time it operates. I tried
> using a current limited supply and fresh ICs, and the driver board drew
> the full 3A. That current should not damage the ICs, but it did -- they
> show a short from Vdd to ground now. I've gone through six pairs of
> drivers now, at $3.80 per chip. Seems clear that it's oscillating in a
> bad way, but I can't tell how! I cannot comprehend what abnormal
> operation would cause it to destroy itself like this -- they are
> supposed to be super-tough devices. Any ideas?
> Mike Poulton
> MTP Technologies
> Not only do I speak for my company, I AM my company!
> Live free or die!
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup