The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
NNTP-Posting-Date: Thu, 21 Nov 2002 11:18:51 -0600
Subject: Re: Woofer repair
Date: Thu, 21 Nov 2002 12:29:22 -0500
X-Newsreader: Microsoft Outlook Express 6.00.2600.0000
X-Abuse-and-DMCA-Info: Please be sure to forward a copy of ALL headers
X-Abuse-and-DMCA-Info: Otherwise we will be unable to process your complaint properly
The woofer is not connected to a crossover.
It's in free air and it isn't the charcateristic resonance peak I'm talking
I'm asking ....what construction detail would lend itself to this kind of
The woofer is obviously defective.
"Ban" wrote in message
> EBG wrote:
> > I have an old EPI 6" woofer that I'm looking at and putting it on my
> > function generator, the speaker distorts badly from around 40hz to
> > 120hz but fine at all freqs above and below.
> > I've never really indulged into the world of woofer construction and
> > repair other than knowing the basic principles.
> > There is no surround problem....there is a very small pinhole in the
> > cone I could fix....but what exactly is going on when a woofer won't
> > perform at a specific band of frequencies like that?
> > It will break up between 40 and 120 hz and also when I "move it"
> > manually between a certain range in it's travel.
> > There doesn't seem to be any impairment of the cone at all....nice and
> > smooth in when I move it back and forth.
> > And it breaks up straight out of the function generator so
> > it's not getting much power.
> > THANKS
> your woofer seems ok to me, but not your knowledge...
> The function generator has probably 50 Ohms impedance. Now when the woofer
> has 5.5 Ohms DC-resistance, at low frequencies this is a 20dB divider, (at
> the woofer terminal there is only 1/10th of the open circuit voltage).
> With higher frequency there is the resonance of the woofer. At this point
> might have without enclosure around 50 Ohms impedance, so you have now 5
> times the voltage across it than before.
> At higher frequencies the impedance goes down again to nearly the same
> as the beginning.
> I advise a good book:
> Joe D'Appolito: "Measuring Loudspeakers"
> ciao Ban
> electronic hardware designer
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup