The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
From: firstname.lastname@example.org (Tom Bruhns)
Subject: Re: How to get quiet AM radio reception with an inverter nearby ?
Date: 22 Nov 2002 22:37:40 -0800
NNTP-Posting-Date: 23 Nov 2002 06:37:40 GMT
You'll need to keep the interference away from the radio (as in using
a better inverter with more shielding and filtering), or the radio
away from the inteference (as you did locating it remotely). You MAY
get lucky with turning the radio to null the inteference. Sounds like
locating the radio away from the inverter has the most promise. If
you run the speaker leads literally underground, and provide some
filtering on them on both ends where the come out of the ground, I
think you have a good chance keeping them from acting like an antenna
and transmitting the hash to the radio. You may be able to acomplish
that without actually burying the speaker line, but at least put it on
the ground, and add RF chokes at each end.
Another way to do it is to feed the radio's audio output into an FM
modulator and "broadcast" it to your cabin.
Yet another possibility is to use a radio that accepts an external
antenna, and put up an antenna a ways away from the interference
souce, but that's not guaranteed to work and can be a hassle.
There may be some other ways to skin the cat...
"Ray" wrote in message news:...
> I have a cabin partway into the mountains.
> I use a car radio powered by 12v battery for quite good AM radio reception,
> except for when I turn on my generator or inverter for lights etc.
> Then the buzz and static completely overwhelms the stations.
> I tried setting up the radio far away from my power wiring, so that at the
> radio location,
> I get clean sound. But when I extend the speaker leads back into the
> the buzz again feeds back into the radio.
> Any idea's how to help this ? I assume that because I am in an
> elecrically quiet location
> the radio is able to run with AGC wide open, but this allows full
> amplification of the buzz.
> Is there any way to block the interference from feeding back into the
> speaker wires to re-enter the radio front end ?
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup