The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
From: John Larkin
Subject: Re: CMMR op amp outside voltage rails ?
Date: Tue, 03 Dec 2002 18:24:44 -0800
Organization: Posted via Supernews, http://www.supernews.com
X-Newsreader: Forte Agent 1.91/32.564
On 04 Dec 2002 00:30:40 GMT, firstname.lastname@example.org (Gibbo) wrote:
>I have simulated and breadboarded (they almost agreed !) an amplifier that we
>need with the following specs:-
>Differential voltage input of -60mV to +60mV
>This could be sitting on an offset between -5 volts to +50 volts
>Available power supply is a single rail 5 or 6v (not yet decided)
>Gain of 50 and 500 (switchable)
>Bandwidth DC to 1KHz
>Gain accurancy better than 1%.
>Offset accuracy less than 0.05 volts on the output.
>Temperature/time drift of offset is not such an issue as the micro periodically
>calibrates for this. Though of course it would be nice to remove this
>My solution uses 3 op amps. One of them to remove the offset on the input. One
>as the differential amp, and one for the gain There has to be a less
>I bet there's a single package that will do it all ?
Doesn't LTC make an 'over the top' opamp? And Burr-Brown makes a
diffamp that tolerates huge common-mode voltages.
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup