From: Watson 'Atto Parsec' Name
Subject: Re: audio line specifications
References: <3DEE2757.EE79B063@crf.canon.fr> <3DEFD744.3A2D8C8D@gv.net>
X-Newsreader: MicroPlanet Gravity v2.60
Date: Sat, 7 Dec 2002 08:52:12 -0800
NNTP-Posting-Date: Sat, 07 Dec 2002 09:55:18 PST
Organization: InReach Internet
In article ,
> I read in sci.electronics.design that Watson 'Atto Parsec' Name
> wrote (in ach.net>) about 'audio line specifications', on Fri, 6 Dec 2002:
> >Well, I said high impedane, which is the vector sum of the resistance
> >and reactance. If it's high impedance then the capacitance must be very
> 200 to 1000 pF typically.
> >In any case, I could hear the diff between a short cable and a
> >long cable as far as high end rolloff goes, with the cheap crystal
> >mikes, or were they ceramic, I forget which.
> Ceramics tended to be nearer 1000 pF. What you heard might be loss due
> to the *loss resistance*, not capacitance, of the PVC insulated cable.
> For crystal microphones, use polythene-insulated cable.
Hey, look. This was back in the toob (aka valve) days, when the tape
recorder's microphone was a box the size of a carton of cigarettes, and
the microphone cables were covered with cloth braid. I don't even think
they had an idea of using PVC, the dielectric was probably rubber.
Back in those days, every budding audiophile like myself had their heart
set on getting a Shure or ElectroVoice cardioid microphone, so they
could make a decent sounding recording. But those were way out of my
budget. I couldn'e even afford the matching transformer.
My email address is whitelisted. *All* email sent to it
goes directly to the trash unless you put NOSPAM in the
Subject: line. alondra101 hotmail.com
Don't be ripped off by the big book dealers. Go to the URL
that will give you a choice and save you money(up to half).
http://www.everybookstore.com You'll be glad you did!
Just when you thought you had all this figured out, the gov't
changed it: http://physics.nist.gov/cuu/Units/binary.html