The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
From: Ned Konz
Subject: Re: Thin LED's
Date: Thu, 19 Dec 2002 18:52:06 -0800
Organization: Posted via Supernews, http://www.supernews.com
References: <email@example.com> <3E013877.5ABCCC88@earthlink.net> <3E01D052.3536D50D@tiac.net> <firstname.lastname@example.org>
> The original idea was to have plastic sheet with LED's that
> would fit on a guitar fretboard and have the ability to provide
> chords and scale shapes etc. These guitars are available with LED's
> embedded in the fretboard (Fretlight). I would
> like the ability to fit this to your own guitar and remove it
> quickly. The fret heights on most guitars range from 0.76mm to 1.09mm, so
> I think the LED's would interfere with the string when pressed
> down, bent etc. What do you think?
You can get LEDs that are:
0603 size, 0.55mm tall: http://rocky.digikey.com/WebLib/Lite-on/Web
0402 size, 0.5mm tall:
If you use a 0.13mm circuit board, you could get below 0.7mm total height.
But where would you put it? You'd have to be able to fret the strings
without making them buzz...
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup