The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
Subject: Re: How to check for a 50 or 75 ohm connector
Date: 22 Dec 2002 22:26:42 GMT
References: <3E053579.AFE0BFDF@sympatico.ca> <3keudKjAZXB+Ewcs@newbrain.demon.co.uk> <firstname.lastname@example.org> <1fzeD1n3UdB+Ewe7@newbrain.demon.co.uk>
NNTP-Posting-Host: host81-7-61-116.surfport24.v21.co.uk (220.127.116.11)
DarkMatter wrote in news:email@example.com:
> Coax hasn't been used in ethernet networks since the 2 Mb/s days, or
> obscure topologies like TCNS.
Um, no quite true old boy. 10base2 was 10Mbps. Throughput was slower
(compared to a switch based network rather than a hub based one) due to all
cards sharing the same bandwidth, but I assure you that the bandwidth was
10Mbps. The biggest drawback was some clod removing the terminator or t
piece from his card.
Brian is correct. The bag, since it contains loads of t pieces, is most
likely full of ex-LAN bits. A dead giveaway would be a couple of 50R
terminators (look just like BNCs with a plastic end cap where the cable
would go) in the bag with them. These you _could_ bell out with an Ohmmeter
to ascertain their impedance.
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup