The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
From: Joe Legris
User-Agent: Mozilla/5.0 (X11; U; Linux i686; en-US; rv:1.0.1) Gecko/20020830
X-Accept-Language: en-us, en
Subject: Re: Max232 and 8051 drivin' me crazy
References: <firstname.lastname@example.org> <email@example.com> <firstname.lastname@example.org> <email@example.com> <firstname.lastname@example.org> <3E0CE73E.email@example.com> <firstname.lastname@example.org>
Date: Sat, 28 Dec 2002 00:30:45 -0500
NNTP-Posting-Date: Sat, 28 Dec 2002 00:30:01 EST
Organization: Bell Sympatico
Nico Coesel wrote:
> Joe Legris wrote:
>>Michael Culley wrote:
>>>>Just a hint though (don't feel offended); it's much easier to have the
>>>>wires run at the bottom of the board.
>>>No offence is taken, I'm grateful for any suggestions. The first time I
>>>wired it up I made the wires too short and couldn't get the eprom out. :-)
>>Normally the wires are routed AROUND the IC's, not over them. Don't put
>>wires on the bottom unless there is a good reason to do so - it makes
>>soldering very difficult. That's why there are holes in the board.
> I don't agree here. If you have a full board, you're better of with
> the wires at the soldering side. If you don't have room to solder
> anymore, the wire you're using is too thick :-) Been there, done that.
> Where I work we use wire intended for winding transformers/inductors
> ('monkey's hair') isolated with a low-melting temperature isolator to
> make prototypes. This also reduces the time necessary for stripping
> the wire. The isolation 'dissapears' when the joint is soldered.
That's a good idea, but for a circuit that dense I'd go straight to a
PCB in any case.
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup