The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
From: "Matt Foster"
Subject: Re: RS232 newbie - in need of assistance!
X-Newsreader: Microsoft Outlook Express 6.00.2720.3000
Date: Fri, 3 Jan 2003 22:13:17 -0000
NNTP-Posting-Date: Fri, 03 Jan 2003 22:13:13 GMT
Organization: blueyonder (post doesn't reflect views of blueyonder)
X-Received-Date: Fri, 03 Jan 2003 23:13:14 MET (news01.chello.no)
Jusging by around page 20 of
Do i need 5.068?
"Michael F. Coyle" wrote in message
> "Matt Foster" wrote in message
> > Ok
> > Here's my first attemot at a schematic - please ruthlessly rip it to
> > laugh at my incompetence and then give me a better one :-D
> > http://matthewfoster.myby.co.uk/lousyattempt.jpg
> Hi Matt,
> It's pretty good but I would suggest a few changes:
> 1. The switches should not be in series with the resistors -- when a
> is open, the input pin does not go down to zero volts. Instead it floats
> around between 0 and 5V because MOS inputs are high impedance.
> Instead, connect each input to a resistor to 5V and a switch to ground.
> When the switch is open the resistor pulls the input to 5V; when the
> is closed, the pin is grounded (and as a side effect, current flows
> the resistor to ground, which needn't concern us here).
> A further simplification is to eliminate the resistors altogether! (Just
> have switches to ground.) Port B on PICs have internal pullup resistors
> that can be turned on within the program. This saves you the five
> 2. If you havent bought the 16F84 yet, consider using the PIC16F628
> It's a newer part, has more memory, and has a built-in UART which makes
> programming this application a snap. You would have to do your serial
> transmission in software on the 84.
> If you go for the 628, you may have to use a different crystal frequency
> make the built-in baud rate generator to work correctly. Most standard
> rates are unrealizable with a 4 MHz oscillator. A better value to use is
> 3.6864 MHz. Then all standard baud rates from 300 to 230,400 are
> See the 628 data sheet for UART and baud rate generator details.
> 3. Check your MAX232 data sheet -- mine shows 1uF capacitors, not 10uF.
> think some older data sheets used 10uF.)
> 4. I haven't checked your serial port pinouts -- you're on your own there
> But you're definitely on the right track.
> Hope this helps. Good Luck!
> - Michael
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.434 / Virus Database: 243 - Release Date: 25/12/2002
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup