The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
From: Spehro Pefhany
Subject: Re: Switching Stepper Motor On/Off
X-Newsreader: Forte Agent 1.92/32.572
Date: Fri, 10 Jan 2003 18:45:00 GMT
NNTP-Posting-Date: Fri, 10 Jan 2003 13:45:00 EST
On Fri, 10 Jan 2003 14:36:16 GMT, the renowned Stan F.
>I have some small-volume digital liquid pumps that I'd like to turn on/off.
>The pump itself is a stepper motor controlled by the circuit board. I've
>tried interrupting some transistors to turn off the motor, but no luck. Is
>there an area of the board or some individual component that would control
>the on/off state of the motor, or is it more likely built into the "brain" of
>the circuit board.
>I'm trying to set up a remote float switch to turn the pump on/off.
>Any help would be appreciated.
It's going to be difficult with your rudimentary knowledge and no
schematic. If you break one or two of the wires to the stepping motor
with a relay, that will probably work fine. There are likely 4 or 6
wires going to the motor.
"it's the network..." "The Journey is the reward"
firstname.lastname@example.org Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog Info for designers: http://www.speff.com
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup