The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
Subject: Re: RF-Amplifiers (again)
Date: 15 Jan 2003 22:22:59 GMT
Organization: Your Company
NNTP-Posting-Host: ms137dhcp147.marine.usf.edu (220.127.116.11)
firstname.lastname@example.org (Jean Lestrale) wrote in
> Dear Karsten,
> The best way to estimate the output voltage of an RF amp
> (in RF volts) is to say that it is equal to or perhaps
> slightly less than the DC voltage on the plate (or the
> collector, etc.) of the final amp output stage. Transistor
> amps usually have a much lower voltage (and higher current)
> output than tube amps, for the same power level...
> All the best,
> Jean Lestrale, W2FGV
> President, Advanced PCB Design
So,there is no way to figure out which output voltage a RF- amplifier can
Maybe you can look at this:
This is a datasheet of a RF-Amplifier (50 Ohm's). the given 50 Ohm's
caused my calculations in the posting above.
My final question is again: Am I able to calculate the output voltage by
the given datasheet for a 50 Ohm system???
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup