The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
From: "Shaun Davy"
References: <6nMV9.26186$jM5.email@example.com> <3E27A064.firstname.lastname@example.org>
Subject: Re: Making 2 Layer PCB's
X-Newsreader: Microsoft Outlook Express 6.00.2800.1106
Date: Fri, 17 Jan 2003 17:51:19 +1100
NNTP-Posting-Date: Fri, 17 Jan 2003 17:41:13 EST
Organization: Telstra BigPond Internet Services (http://www.bigpond.com)
Sorry forgot to state (assumed didn't make any difference to be honest) that
i will be just using double sided copper board.
I Have a CNC controlled machine that can cut vinyl that i will stick to
board then etch with suitable solution that doesn't chew the vinyl. tried it
before and was sucessful and looked good.
But i think u answered my question anyways. So i just need to get a hold of
and use "Feedthru Pads".
Any ideas where i would get them from. I am in Australia and have never seen
that sort of thing at Dick Smith.
Thanks for the advice
"Tom Woodrow" wrote in message
> Made em at home, made em at work. Used kepro pre-reststed copper clad
> FR4 (double sided) laminate, a circuline forescent light for exposure,
> and a ceramic bowl crock pot for etching.
> Cleaned the resist off after etching with a freon degreaser. It worked
> but it was an environmental nightmare.
> Layout the board so that components can soldered on both sides of the
> board whet a feedthru is necessary.
> Use accessable feedthru pads where you can solder a jumper wire from one
> side to the other (use this instead of a plated thru hole)
> If you need the place a feedthru jumper under a component, solder the
> feedthru jumper in BEFORE you install the component.
> As for allignment top to bottom when etching, place unsed pads at
> opposite corners (or on all four corners if you like) of your layout.
> Drill these holes BFFORE you expose the double sided copper laminate.
> Allign your film on one side then drill the corner holes, then expose
> that side. To expose the second side allign your film on the backside
> using the same corner holes. The smaller the holes, and the more
> accurtely they they are centered in the pads on the file, the more
> accurate the side to side allignment will be.
> All the above is in the saaumption you are using photoresist board
> material (kepro or such).
> Good luck
> Tom Woodrow
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup