The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
From: Tom Woodrow
User-Agent: Mozilla/5.0 (Windows; U; Windows NT 5.0; en-US; rv:1.0.2) Gecko/20021120 Netscape/7.01
X-Accept-Language: en-us, en
Subject: Re: Making 2 Layer PCB's
References: <6nMV9.26186$jM5.email@example.com> <3E27A064.firstname.lastname@example.org> <3E27AD47.FC85A811@autometer.de>
NNTP-Posting-Date: Fri, 17 Jan 2003 23:37:20 GMT
Organization: AT&T Broadband
Date: Fri, 17 Jan 2003 23:37:20 GMT
I meant to say that, but it was past my bed time and I ran out of good
words. You are correct, that is what I was trying to say when I went
Tilmann Reh wrote:
> Shaun Davy schrieb:
>>But i think u answered my question anyways. So i just need to get a hold of
>>and use "Feedthru Pads".
>>Any ideas where i would get them from. I am in Australia and have never seen
>>that sort of thing at Dick Smith.
> Tom was talking about simple small wire pieces, soldered in to connect
> a pad on the top layer with one on the bottom layer (without a component
> For parts that can't be soldered on the top layer, you should use short
> tracks to somewhere outside of them where you can solder both sides,
> and place a "via" there which later is done with this wire piece.
> Dipl.-Ing. Tilmann Reh
> Autometer GmbH Siegen - Elektronik nach Maß.
> In a world without walls and fences, who needs Windows and Gates ?
> (Sun Microsystems)
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup