The Cyber-Spy.Com Usenet Archive Feeds Directly
From The Open And Publicly Available Newsgroup
This Group And Thousands Of Others Are Available
On Most IS NNTP News Servers On Port 119.
Cyber-Spy.Com Is NOT Responsible For Any Topic,
Opinions Or Content Posted To This Or Any Other
Newsgroup. This Web Archive Of The Newsgroup And
Posts Are For Informational Purposes Only.
From: "Phil Allison"
Subject: Re: Choosing the right transformer
X-Newsreader: Microsoft Outlook Express 5.50.4522.1200
Date: Sun, 19 Jan 2003 15:37:55 +1100
NNTP-Posting-Date: Sun, 19 Jan 2003 15:27:00 EST
Organization: Telstra BigPond Internet Services (http://www.bigpond.com)
"Greg" wrote in message
> I need to design a power supply for a classD amplifier (audio). The power
> supply must be ripple-free so I'll use a regulator. However, I don't
> know how to choose the transformer and regulator ratings a since in audio
> you don't really need the full power all the time.
> I read in TI datasheet
> that if you want a 19V supply delivering an average power of 60W (25W per
> channel + 15% of heating) in 4 ohm, the peak power required is 120W (twice
> the average power). The peak current needed is then around 6.6A.
> Then they say that a power supply delivering 1/8 of the average power
> = 6.25W) is good enough for audio. My question is: when choosing the
> transformer and regulator ratings, what do you need to satisfy?Average
> demand, 1/8 of average demand or Peak demand?
** There are several issues - the regulator must supply the peak curent
demand though an output filter cap could reduce this figure a lot - it
depends on the signal - unclipped music, clipped music or even square waves.
The heatsinks for the regulator may be OK at the 1/8 power, if
thermal protection is provided in case this rather artificial figure is ever
The AC transformer will need to supply the peak too but the long
term average is way lower. If it is too small the regulation will be poor
and make your linear regulator design very difficult and lossy.
> Approximately, using 15V for the secondary winding (20V/1.4) I get:
> Peak demand is : 15V*6.6A = 100VA with a regulator able to supply 6.6A
> Average demand is around 15V*4.5A = 67.5VA
> 1/8 of average is : 15V*0.56A = 8.5VA
> Those are quite different numbers in term of size and cost so I'd like to
> know what are the common design techniques. Are the decoupling capacitors
> there to supply that peak demand when it is needed? Are there better than
> average regulators that comes to mind for this kind of application?
** I suspect the 67 VA figure is nearer the go - as a compromise between
good regulation and long term capacity.
Class D amps do not normally need a regulated supply - that kinda
ruins the whole benefit of it don't you think ?
Go Back To The Cyber-Spy.Com
Usenet Web Archive Index Of
The sci.electronics.design Newsgroup